+359 879 201 665 / +359 886 098 835
Home »Airsoft »Airsoft Batteries and Charges »AIRSOFT BAT.NP POW.1300MAH 11.1V 20C PEQ MCRO LIPO
AIRSOFT BAT.NP POW.1300MAH 11.1V 20C PEQ MCRO LIPO
Buy -BGN43.90
In stock:
Airsoft center
Manufacturer:Product #:
WE Europe1515040
Battery Type:Capacity:Size:Connector:
Li-Po1300 mAhmmMini Tamiya
Description
Voltage:11.1v
Capacity: 1300mah
Size:



WARNING
USE A LiPo BALANCE BATTERY CHARGER ONLY!
ALWAYS CHECK CELL VOLTAGES BEFORE AND AFTER CHARGING.
MINIMUM CELL VOLTAGE 3.3V. FULLY CHARGED VOLTAGE IS 4.20V CELL MAX. MAXIMUM CHARGE CURRENT 3C.
DO NOT LEAVE THE BATTERY UNATTENDED DURING CHARGING PROCESS.
ALWAYS USE A CHARGING BAG WHEN CHARGING.
STOP USING THIS BATTERY IF THE TEMPERATURE EXCEEDS 70C OR THE CELLS SWELL AND EXPAND. FAILURE TO COMPLY MAY RESULT IN AN EXPLOSION, FIRE AND VENTING OF THE CELLS.

+ See more
Products from same category
BATTERY, 11.1V 900 MAH, LI-PO, SINGLE STICK
Compatible with the CZ 805 Bren Ref. 18197

The biggest reasons to use a Li-Po is its smaller size and better power efficiency. Most Li-Po batteries are about the same size as a mini-type battery and is equal in power to a large type NiMH battery. No need for battery slings, battery boxes, or big batteries strapped on to guns. Li-Po is a power source for small carbines, PDW's, SMG's, etc. that doesn't require you to spoil the look of the gun, or run the risk of running out of power in the middle of a battle.
Unlike traditional batteries, Li-Po gives a stable Rate of Fire, Throughout its use. Also, it is not necessary to discharge Li-Po batteries before charging them, allowing the battery to be charged in-between games.

Battery specs:
•Configuration: one block.
•Voltage: 11.1V.
•Capacity: 900mAh.
•15C Continuous discharge rate of 13.5 amps with 18 amp bursts.
•Comes with align balance connector.
•This pack is ideal for M130 to M160 upgrades.
•Replaces a 10.8V to 12V NiMH pack.
•Ultra-advanced Li-Po battery technology.

To prolong the life of a Li-Po battery:
Never completely discharge the battery.
Stop using the battery the moment you hear the Rate of Fire goes down.
Charge the battery before storage.
IMPORTANT: you must use a Li-Po charger, no exceptions.

When using Li-Po batteries in upgraded AEG's, it is advisable to have a total upgrade, including spring, cylinder-parts, gears and motor. Simply installing a more powerful spring, and then using a high voltage battery to power the AEG will wreck one or more components in your gearbox.
ULTIMATE motors are designed specifically to power, upgraded AEG's, and are built to handle higher voltage
BGN32.90